Any machine must pay attention to maintenance while in use. The stability and normal operation of the machine are inseparable from daily maintenance. The correct maintenance method can not only improve the working efficiency of the laser cutting machine, but also prolong the life of the laser machine, which can be more good to save production costs and win greater benefits. Regarding how to maintain the laser cutting machine, ACCTEK has compiled the following related knowledge for you, I hope it will be helpful to you.
 
1. The change of water and water tank cleaning (recommend clean water tank and replace circulating the water once a week)
Note: the machine work before must ensure that the laser tube is full of circulating water.
Circulating water quality and water temperature directly affects the service life of the laser tube, it is recommended to use pure water and to control the water temperature below 35 ℃. For more than 35 ℃ to replace the circulating water, or to add ice to reduce the water temperature, water (cooling machine, suggest the user select or use two-tank).
Clean water tank: first, turn the power off and remove water inlet pipe, let the laser tube of water into the tank automatically, open the water tank, pump and clear the dirt on the water pump. Good clean water tank clean, replace the circulating water, the water pump to restore back into the water tank, the connection pipe inserted into the inlet of the pump, tidy up the joint. The pump power alone, and run 2 to 3 minutes (the laser tube is full of circulating water).
2. The cleanness of the fan
After long time use, it can make the fan inside the accumulation of a lot of solid dust, let the fan make a big noise, in addition to flavor and is unfavorable to the exhaust. When appear insufficient suction fan smoke not free, turn off the power supply first, will be discharged into the duct and the duct on the fan, remove the inside of the dust, and then put the fan on, and pull out the inside of the blades, until clean, then put the fan installed. Then it can support the co2 laser machine well working.
3. The lens cleaning (advice before work every day, clean equipment was turned off)
The laser cutting machine has three pieces of reflector and 1 piece of focusing mirror  (1 reflector in the laser tube, the launch of the exit is at the upper left of the machine, the reflector is in the left side of the beam’s # 2 and # 3 mirrors in laser head on top of the fixed part, is located in the lower part of the laser focusing mirror adjustable lens barrel), after focusing laser is through the lens reflex, emitted from a laser. Lenses can easily touch dirt or other contaminants, cause loss or damage of lens of laser, no. 1 and no. 2 don’t must be removed, while the lens cleaning need to dip in cleaning fluid to clean lens paper carefully wipe up along one edge of the lens central to rotary. No. 3, lens and focus lens from the frame, in the same way, to wipe, wipe after the completion of the same back then.
Note: (1) The lens should be wiped gently, do not damage the surface coating;
(2) Should take put down gently wipe process, prevent fall;
(3) Focus lens installation please be sure to keep the concave downward.
 
Regarding how to maintain the laser cutting machine, the above is some relevant knowledge that ACCTEK has compiled for you. If you have other questions about the laser machine, you can leave us a message, our staff will reply to you in time, hope it will be helpful to you .